smart converter charger for a teardrop trailer

#SMART CONVERTER CHARGER FOR A TEARDROP TRAILER FULL#

For RV systems, they feature high continuous. Using state-of-the-art, converter switch-mode technology, Go Power Battery Chargers are reliable, compact, and lightweight and are designed specifically to extend the life of deep-cycle battery banks. Therefore, the module is NOT a replacement for a BMS.Īlthough I haven't done so yet, I plan on replacing my existing converter/charger in my travel trailer RV, with the same setup. Go Power Smart Battery Converters offer fast, accurate battery charging at a reasonable cost. We like the smart battery chargers because we can use them to help start our. However, make no mistake, these specs are for the battery pack and not for individual cells. This best camper battery has a ton of five-star reviews and they have been. If you look at the IQ-LIFEPO specs, the Bulk and Absorption voltages are right on for LFP, as are the high and low triggers. I and several of my Ham friends have been using the IOTA DLS converter/chargers and all of us have been very happy.quality products. First off, I have absolutely NO stake in IOTA Engineering. However I have been using it to top off the cells.VERY closely monitored of course. Still waiting on the Chargery BMS8T delivery (en route).

I just recently purchased the the IQ-LIFEPO module, which is a simple external swap with the IQ4 module for charging my (currently being constructed) LFP 280AH pack. I also have been using it with the IQ4 module to charge/top off my Sealed Lead Acid Batteries. Not a lick of problems, and not a lick of 'hash' (noise) on the radio bands.

#SMART CONVERTER CHARGER FOR A TEARDROP TRAILER FULL#

Thus, when the batteries have charged to ~90%, the charger goes into Float at 13.6v (which is my batteries' resting voltage) and after ~4 hours at Float, with no loads on the batteries and no fluctuation of voltage, the charger goes into Storage mode, which is basically 'asleep' - it's passing 0 current into the batteries unless the battery voltage falls below my set Storage voltage of 13.2v if the battery voltage falls below that setting, the charger will turn back on and run a full charge cycle as necessary.Ĭlick to have been using the IOTA DLS-55 with the IQ4 module as a power supply in my Ham Shack for all my radio gear for 15 years. The 'storage' voltage will be a lower voltage setting than 'float' voltage for my batteries (ignore the screenshot, again I'm running a beta FW version and the settings reverted to default when I connected to the device to take screenshots) I set bulk/absorption to 14.4v, Float to 13.6v, and Storage to 13.2v. Changing the battery preset to lithium will automatically turn off reconditioning, but care must be taken when selecting a 'user-defined' battery preset, because reconditioning is not automatically turned off in a user-defined preset. The 'recondition' voltage will be inapplicable for an LFP bank, as reconditioning must be turned off entirely -reconditioning is for Pb batteries only, and is effectively a deliberate overcharging of a lead battery to burn off sulfation, which is not applicable to LFP batteries.

Smart converter charger for a teardrop trailer